 |
|||
|
|||
|
Disassembly Step 1: Remove the body by first pulling the sides out away from the chassis and then pulling up. Step 2: Turn the car over and remove the two screws that hold the front suspension together. The red arrows in the following picture are pointing to these screws. |
|||
 
|
|||
|
Step 3: Pop off the plastic cover that the screws were removed from. Slide the plastic spacers, knuckles,
and springs off the kingpins. Below is a picture of the pieces being removed. Be extra careful not to loose
the spacers and springs they a VERY small. Step 4: Flip the chassis over and remove the screws holding the circuit board to the top chassis plate. The red arrows in the following picture are pointing to these screws. |
|||
 
|
|||
| On to Step 5 >> | |||
 |
| Copyright © Tiny RC, Inc. 2010 | Home | About | News | Privacy Policy |