did battery mod

natedogg4674 · #1 10-16-2002, 10:37 PM

After putting the pcb and motor from my microsizer into my zip, i noticed its much faster, but run time not so good, so i ran two stock zip batteries in parallel, but it seems like run time is the same before i did mod. does anyone know how long i need to charge it, ive been doing 2 full charges on my microsizer charger, but it runs the same time. any suggestions?.my other question is what motor everyone suggests for speed, i ran the stock micro motor , then tried the zip nos motor, the micro motor much faster.

Axel · #2 10-16-2002, 10:48 PM

For pure top-end speed get the 3.8. But you either have to have a micro board or a multiple batt mod (or something else with higher voltage). This motor might not be the best bet for acceleration though.

Barry · #3 10-16-2002, 11:19 PM

If you have the NOS motor try it instead of the microsizer motor. My NOS motor runs at least twice as fast as the 2.6 in my microsizer.

Sorry I cant help you on the battery issue though.