I was playing around with my X-mod yesterday and decided it was too slow for my taste so I installed a Stage II motor, I think it was the yellow one. Anyway, I think i must have tightened the screws too much because it seems as if the mesh is to tight between the gears. Is that even possible? Or could it be that the "D" shaped axle wasn't straight? No big deal, I'm gonna be doing surgery on it tonight so I will figure it out.
did you swap out teh gear that goes with that motor?
__________________
MY XMOD!
Yellow skyline
Springs: Hard all around
1.5 degree toe in
hard slicks
Top Speed stage 2 motor
full bearings
AWD
6 spoke wheel upgrade
energizer rechargeables
6 Cell Upgrade
Linear Mode
