My 27Mhz ZZ makes nice tight little left hand circles about 1' in diameter. But my right hand turns look almost to be double that in diameter. Not nearly as sharp.
Anyone else have this problem?
(I swear I saw a thread on this but now I can't find it. If anyone can point me to it I would appreciate it.
Or if you have info that would be good too...)
Same problem but worse turning radius in both directions. I read that the side with the motor/transmission is the cause of the effect. I have a heavy industrial gauge wire as an antenna (for the moment) and it seems to have exacerbated the problem. I have a 5inch turn to one side, 1 foot to the other.
-slackerZ
__________________
"Did I.Q. 's just drop sharply while I was away?"- Ripley
Linear Mode
