TinyRC.com - Search Results

		TinyRC.com > Search Forums
Search Results

Showing results 1 to 7 of 7
Search took 0.09 seconds. Search: Posts Made By: mini-xmen

Forum: Mini-X

03-17-2004, 11:00 AM

Replies: 17

4WD shaft mod + 180 motor mount

Views: 4,957

Posted By mini-xmen

Hi, I had the problem with the traction roll...

Hi,

I had the problem with the traction roll only with motors equipped with neo magnets.
I am driving on pvc rooms. Very very soft in the rear, if I press the car down, it stays on the floor. In...

Forum: Mini-X Parts and Hop-Ups

03-14-2004, 09:31 AM

Replies: 3

front wheel slop

Views: 2,532

Posted By mini-xmen

This will not go!!! You will loose the dogbone...

This will not go!!!
You will loose the dogbone if you steer, or it will interfere and the wheel will be blocked!!!
The slope is not the problem, it is the cheap and soft material of the axle!!...

Forum: Mini-X

03-03-2004, 07:50 AM

Replies: 19

burned out motor

Views: 1,578

Posted By mini-xmen

The bent steel plate is about 0,75mm thick. To...

The bent steel plate is about 0,75mm thick.
To mesh the theeth correct, I can slide the motor up and down a little.
The gears are from local hobby shop, 25t or 30t modul 0,5.
You only have to cut...

Forum: Mini-X

03-03-2004, 02:52 AM

Replies: 19

burned out motor

Views: 1,578

Posted By mini-xmen

To hold the bearing at the rear diff, the engine...

To hold the bearing at the rear diff, the engine plate is so long to cover all 4 posts. You have to cut the two posts in the front, where formerly the motor was tied down, they should be the same...

Forum: Mini-X

03-02-2004, 01:21 PM

Replies: 19

burned out motor

Views: 1,578

Posted By mini-xmen

Sorry wrong one, but as you see I am new here!!!!...

Sorry wrong one, but as you see I am new here!!!!

Sorry!!

Forum: Mini-X

03-02-2004, 01:20 PM

Replies: 19

burned out motor

Views: 1,578

Posted By mini-xmen

A second pic!! The motor is a GPM MH038...

A second pic!!

The motor is a GPM MH038 torque.

But still to slow!!
Does the stock esc hold up 9,6V??????
I would like to keep up with the 1:10 touring cars!!!!

Bye

Forum: Mini-X

03-02-2004, 01:16 PM

Replies: 19

burned out motor

Views: 1,578

Posted By mini-xmen

Hi, for those who have not done any motor...

Hi,

for those who have not done any motor conversion still.
I burned 3 stock 4wd motors, all of them lost their armature.
They get to hot!!!
Now I am using a 2mm steel shaft with 2...

Showing results 1 to 7 of 7

Forum Jump

All times are GMT -5. The time now is 07:30 PM.