Have you had problems with your 2.8 or 3.4 motors?

[NatakuARN]

I would like to know if the problems are anomalies or are certain factors involved. A few factors I have considered are:

- Dual/Triple/Etc. Cell or Single Cell
- Which PCB is in your zip (ie. Older one prior to the Black Mustang or new one in the 2 fast 2 furious kits.)?
- How often do you run your cars or more specifically the one that had the 2.8/3.4 motors?
- Is your racing surface Flat? Do you race over carpet or similar surfaces?
- Which gear combo do you use?


I have not had any problems yet; all my cars are stock with either blue or red gears, and newer PCB’s. I run them on semi flat tile and sometimes over carpet, they get used once or twice a week.

[Bad Company]

I haven't had any trouble with mine, but I am in the same boat as you. All newer PCB's, all stock except one, and flat surface.

[rfnagel]

No problems at all over here with a stock 60-7007 PT Cruiser (I think it has the 2nd PCB in it).

[rfnagel]

Almost forgot, my nephew has the stock red Mustang, and the motors work fine with it. AFAIK that one has the original PCB of the three.