Best Booster PCB?
Well, as many of you remember i was the one inquiring about methods for project Ultimate 350Z.
I got the wheel swap all done and i must say, it is awesome. However when i was handling the car i accidentally removed the wire i had soldered to my motor clip (i have a dual cell). While attempting to re-solder, i wasnt paying attention to my soldering iron's heat and unfortunately set fire to the rear of my bit char-g. My question is this: should i swap my bit booster pcb into a spare microsizer chassis, or buy an LXX or MS pro? Boost is a must for this project, as well as good range. Which pcb puts out the most power to the motor and which has the best range? Any help will be appreciated. I will try an snap some pics of the pullback wheel mod soon (i managed to make it so that both wheels stick out equal amounts and only about 1.5mm--debating whether widebody is necessary).
Last edited by r34 racer; 05-07-2003 at 12:48 AM.
|
Threaded Mode
