not sure if this was posted be4 but for all those people who wanted to put camber on there front wheels of bits this is how...i got 2 versions of it...
Version one:
1take out the front wheels as if you are going to do a fullsize wheel mod
2put the wheel pin back in the knuckle with out the wheel on it (just enough so you can take it back out)
3take pliers and bend the pin up(not to much!!)
4take the pin out from the knuckle
5and put the wheel and pin back into the kunkle and assemble your car back up
6repeat for the other side
Version 2:
1take out the front wheels as if you are going to do a fullsize wheel mod
2take a drill bit that is about the same size as the wheel pin
3drill into the knuckle at a slight angle
4put the wheel and pin into the knuckle
5repeat for the other side
we thats two versions of putting camber on your car..dont put to much of an angle when drilling or bend the wheel pin to much orellse the wheel will rub agains the knuckel..i only did version one on my project car but didnt test it out yet. i still have to fix the chassi because i did the fulsize wheel mod...version 2 sounds good...but i think they will work ok..if u did this or want to add comments to it, just post it.
Threaded Mode
