|
True 4wd 1:64 scale car...Kinda
Hey everybody,
I've done it, I created a 4wd mini r/c. No it's not a bit char-g entirely, but it is 1:64 scale. I ran into one problem. My steering magnet is not strong enough to turn the wheels on my set up. I have two questions for anyone who knows anything about the motor works pcb boards.(I'm using their steering set up also)
1. Would increasing the voltage allow the magnet with the wires going to it to be stronger?(I'm using rare earth magnets for the two magnets on the side)
2. How would you increase the voltage going to the magnet?(I have 2.4 going to it now and it is not strong enough. Could I replace the tiny wires with thicker ones or is there resisters on the pcb board that I would have to take out.)
Also whatever Ideas you have, just remember I can't sacrafice voltage going to the motors because I'm running two and don't want it to be lower than what it already runs at.
I tested my steering with 1.5v and it did nothing(running through the pcb board that is). I then tried 3v and it turned slightly, but not much ( again voltage going through pcb board). Someone please help. It's like 95% complete and if someone can help me with my steering problem i'll be glad to tell everyone how I actually created this monster. This is my only problem, everything else works.
|
Threaded Mode
