Quote:
Originally posted by novastar512
I started by penciling the different pieces onto the polystyrene. Then I would cut it with an exacto knife, using a laminate board(left over from my kitchen counter) to guide the cuts. Unfortunately, the polystyrene has to be cut with the exacto knife fully through it. Meaning, you can’t cut it on a board, you have to cut it leaning over an edge. This was note much a problem though.
|
... Have you read my post? I didn;t really use a template though. I just drew about 10 3/4 inch barriers and started cutting, and took it from there. I used a T-square, and then I would cut.
However, with my turns, I made them have a 10.5inch radius, and I did use my first one as a template.
Sadly, I can't take all the credit, I had some help from the people at *************.
Threaded Mode
