TRC Alloys Instructions

[HammerZ]

I got my alloys from the very good people at the shop on this site. as you can tell I spent the better part of the day using Babelfish to translate the sheet that come in my TRC Alloys set. Anyway this is what the Babelfish spit out at me, hope this helps.


Packing contents

4 tires
2 front rims
2 tail rims
4 screens
1 rear axle of
2 oh nails
1 gear wheel of
2 knuckles

Reference!
Depending upon rim model and bodyist the widening and/or that necessarily mills out the front wheel housings!
The rim change must take place very praezse. For damage, which results from the change, no adhesion is taken over.


Rim assembly
2x of front wheels of
oh nails by rims in knuckles of pressing oh nails possibly grind!!!

NOT THE RIMS DRILLING OUT!

CAUTION!
It makes certain that the wheels can turn freely, but too much play do not have.
Supernatant oh nails with side cutter separate. Fix the oh nails with second adhesive with 5mm rims.

2x of rear wheels (of it 1x with space ring) possibly grinds itself axle ends to itself the rims aufscieben lets now first the gear wheel onto the axle to push.
Rim with space ring on the oh side without gear wheel fit in. Distance from the gear wheel to abbott and ring 22mm.
rim without space ring on the oh side with gear wheel fit in.
Supernatant axle parts mark, rims off again take and marked ends with side cutter fix.
Gear wheel directly on the rim stick.

Rim plates darkly paint
In order to increase the contrast, it recommends to paint itself the rim plates darkly (sufficiently is also a dark permenenter pin)

Screens use
First release and bars dazzle with sharp measurer remove.

Tires onto rims push

Front wheels changes
Through press against the rounded off edge of the plates cover chassis open
which bend plate to the side (caution! lenkdraethe do not tear) now the screw off
by 2 turns (no more) solve and the knuckles through from the lower Ose raise.
Now the new wheels insert, tighten the screw again and close the platinum final disgust.

Wheel housings mill out
(only with 6mm rim-broad)
Tape in addition a Mignon battery with sleeping paper and under
constant examination the front wheel housings rebore.