i'm new to all of this... but i came across the mod on QFM to extend your antenna range buy cutting or removing the capacitor on the circuit board of the controller.
however, it appears my controller (new MicroSizer Pro) doesn't even have it. or, at least i can't find it! it's not in the same place as the pic provided on the QFM's how-to. don't see an obvious suspect either.
could anyone provide me with a pic of where this capacitor is on MicroSizers (or if there is even one)? or how i can find it myself?
i'm going to look into the mod on the pcb in the car too - just a little nervous about that one. not sure if my soldering iron is small enough!
anyone got any other advice/tips on getting some more range?
Threaded Mode
