|
How to Splice LED's for the Light Kits
OK, I'm going to be using the left over tail light LED's from past projects, but it all applies the same for the head lights, so here we go...
You will need:
2 Light Kits (Or more)
Scissors (Or knife)
Electrical Tape
Do not do this with the light kits hooked up. (Duh!)
First, cut and remove the LED's from your second Light Kit. I suggest cutting them close to the board to have enough wire to rtun them wherever you plan in the car. Seperate the wires on each LED, and use the scissors to strip the ends. Be carefull to only cut away the insulation, do not cut into the wire. It helps to twist the strands in each wire together after striping them.
Last edited by Bad Company; 10-31-2003 at 11:28 PM.
|
Threaded Mode
