Here’s what you need: a carriage bolt, a gas stove (or any other type of flame), hacksaw, potholder, bowl of water, exacto knife, and a shell
1. Cut the head of the carriage bolt in half with the hacksaw.
2. Wrap the potholder around the end of the bolt.
3. Then, turn the flame on and hold in the flame for 2-3 minutes.
4. Take the bolt and insert underneath the shell (with the flat part, that you cut, facing the front, the car) push the bolt until desired height.
5. Put the shell in the bowl of water until cooled.
6. Wiggle the bolt loose from under the shell.
7. Cut the front part of the hump open.
Threaded Mode
