10-17-2002, 03:31 PM
|
 |
It's super useless!
|
|
Join Date: Sep 2002
Location: Alameda, CA
Posts: 642
|
|
|
Alternates for PCB cover
Recently, I just lowered the front tab of the chassis where the body is supposed to lock into thanks to Killboy's suggestion. Problem is that when I try to fit my RX-7 body, it clashed with the PCB cover. It wouldn't go a mm further so that it could meet with the tab thus I removed the PCB plastic cover and it will fit. Currently, I would like to know about some alternate ideas for a cover, preferably short enough to mount the body on the lowered chassis. For now, I'm using a type of laboratory masking film called Parafilm to secure the board from jumping up and down.
|
10-21-2002, 01:09 AM
|
 |
Administrator
|
|
Join Date: Apr 2002
Posts: 3,729
|
|
|
Parafilm sounds like a great solution! Maybe try heat shrink tubing around the whole center section? Or just good old electrical tape...
|
10-21-2002, 02:32 AM
|
 |
l33t camber wizard :)
|
|
Join Date: Sep 2002
Posts: 390
|
|
|
|
10-21-2002, 06:32 PM
|
 |
www.d1gp.com
|
|
Join Date: Aug 2002
Location: TX
Posts: 1,514
|
|
|
just shave some of the pcb cover off...thats what i did..
now its more diagonal...on the sides...instead of curved
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
All times are GMT -5. The time now is 02:13 AM.
|
|
That's what I use.. On my slammed RX-7, though, I didn't need to remove the cover. 
Linear Mode
