this is a huge problem I,m having

[zombiebaby]

when I put my rear axle in it really loose it look like I have changed it so much that I have worn the nubs that keep it held up in is there anyway 2 fix it or am I screwed

[JTM]

glue

[zombiebaby]

that would stop the axle from spinning u think?

[jei$]

ok if the rear axle dont fit n e more, im guessing u r scruedlike they're loose.
i would buy a new one.
JTM, glue dont work if glue happens ,
the rear axle gets stuck

[Silent_NightR34]

there was apost somewere saying that if u put a lil pole throught this hole in the back of the chassi(right under the engine under the chassi)it should stay...

[JTM]

if you use elmers glue on the bottom of each side, then wait for it to dry and trun it with your fingers itll break loose (doesnt like to stick to smooth metal) and create a nice snug vibration free area.

[zombiebaby]

thanks thats a damb good idea I was thinking model glue but elmers would work better

[sipsap]

heat an exacto or razor blade and cut a little slit in front of where the axle snaps in then bend it in to make the hole more snug

[Gpbitfreak]

i read somewhere u can slip a match through the two holes on either side of the axle and it will hold it up.
u might need to cut the match to fit or use a toothpick. if u look i think u will see. its through the hole that u can see the battery through and the other hole on the other side

[spikeymike218]

i was the one who came up with the match idea. heres a link to my post about it:

http://www.tinyrc.com/forums/showthr...le+not+staying

[Gpbitfreak]

see kids these days are so smart