killer- haven't seen those pics in here yet...
just so i get this right, i took pictures of the pcb disconnected from the housing/pot.
you have used 2 resistors in your mod, which i plan to do as well. i got 5.6k resistors this morning. however, there are three points- one to which the existing resisitor is soldred and the two remaining points to which the pot was soldered by the red wires.
i can see where you installed one resistor(the one with the long 'l' bend-top and right) to each point to which the red wires were. the other resistor is installed to the point which the existing resistor was soldered (left) and is soldered to which point?
i can't follow the other instructions as it's not clear what the center/top and bottom leads are? there are two leads on the left side corners of the pcb and one on the right side corner.
o.k., i've spent some time looking carefully at all this. i assume the center point he is refering to is the point on the pcb where the existing resisitor connects to the upper center point on the pot. so, one resistor would be soldered to this point and one of the points to which the a red wire is attached and another resistor is soldered from the same first point of the existing reisitor to the other connection point of the other red wire. i hope i haven't lost you? would this assumption be correct?
