Today I was running my bitmod1 3.5 in my 350Z booster and it went to crap. I had been running it and my Perfection 3.8 in my 350Z to see which one I liked better. The bitmod1 3.5 was by far faster in boost and non-boost mode, so I left it in and put the Perfection 3.8 in another car. After running the 3.5 in my 350Z for a while it just started running super slow. I pullled it out and put it in another car and same results. I put the 3.8 in my Z, and no problems. I looked at the 3.5 and noticed lots of play in the driveshaft of the motor. Did the booster car burn up my 3.5? Anybody have a similar problem? Any enlightenment is greatly appreciated.
