Plantraco shipped out my gear that was bent. Its the shaft that has a white gear, and the black drive gear on the outside.
Anyway, i took off the 4 screws to take off the computer board. Then i took out the 3 screws underneath. I cant get out the next plastic piece. I can get out the rear part, but the section of it that is closer to the center of the tank seems to be stuck. How do you guys pop this piece out?
I dont want to break it
If you guys post a picture of the inside of a rover without the computer board I can show what part im talking about.
Thanks!
this is the part
the part that is held in with those 3 screws