What controller are you using? (Motorworks, Microsizers, etc)
Need to know, to explain the right pinouts.


As to the software, The problem lies with running UserPort.exe
We must have success here for the software to talk out the parallel port.

You said:
4. Ran UserPort.exe (error: Driver does not exist: C:\WINDOWS\system32\drivers\UserPort.sys)
5. I manually copied and pasted UserPort.sys into the windows system directory.


1. Either by the software installation or by manual copy, make sure \windows\system32\drivers\UserPort.sys exists in the directory.
3. Run UserPort.exe
4. Make sure all address ranges are selected from the 'Left' to the 'Right'.
5. Click on 'Start', it should say "Driver Already Started!"
6. if not already started, exit reboot.... goto step 3

Post results.

-Nox