|
fullsize wheel set:
once you have the front apart and the front wheels off the chassis you need to seperate the front wheels from the white peice. First drill a small hole in a peice of wood or an old phonebook or something. This will be used so that the pin can push through the wheel. Place the wheel over the hold int he peice of wood with the white piece facing up. Next make sure the pin is lined up to be pushed into the hole in the wood. Place the nail on the pin (on the white plastic peice side) and then gently hit it with a hammer. It will eventually come out. The pin will probably have bent so you need to straighten it with pliers. Next rip the rear axle set apart so you just have the wheels. You have to pry the gear off the wheel gently using a screwdriver between the teeth of the gear and the rim. It WILL come off but use patience. Drill a hole in the center of the back wheels now. It need to be JUSt bigger than the front wheel pin. Put your new rear wheels where the front ones were and hammer the straightened pin back in. Make sure you don't push it in too much or your front wheels won't be able to spin. Making sure everything is good, place a drop of glue on the white plastic side of the wheels to set the pin in place. YOUR DONE!
Put it back together and now you have a fullsize wheel set.
I've taken my front ones apart but not put larger ones on (not counting my monster truck) becuase i am not sur how it will impact the steering of the bit.
|