Quote:
Originally posted by MicroMike
What up Kit, I'm new around here to. Had same problem with my microsizer. Look at the wheels mounted on the white hubs. Do they tow out a bit or does one look like its not pointed straight when your holding the car ?? I had my right front wheel bowing out, like the pin holding the wheel on the white knuckle was slightly bent. Take a small jewelers flat screwdriver and stick it in between the wheel and the knuckle and bend it ever so slightly to get the wheels pointed straight. Also, you can take your front end apart and see if there is any glue on the inside magnet on one of its sides. This helped greatly for my car and it now goes straight as an arrow. Good Luck !! Mike
|
Ok so, I now know that my Mini RC is actualy a "Super New BitChar-A" so if i'm no mistaken this is porobebly the first generation and I purchased it yesterday. Dough!
As for the steering, I cannot get it to work right. There seem to be too much slack between the hub and shaft of the front rims, plus the slack in the steering linkage accumelates to very bad steering.
What can be done about the range, 5ft at the most... The PCB is a rev 4. Take a look at the pictures Bellow.
Kit
