[Kingofjapan]

hey guys. i didn't want to buy a booster kit b/c it would cost a lot. so decided undergo brain storming. what i came up with is a two motor bit! if have come across that crazy japanese site with the two motor mod. i will mount the motor the same way, but the diff is that one motor will be a 1.0 and the other one will be a 3.0. after careful examination, and much soldering just hooking up the negative lead and the postive leads just doesn't do it. there wasn't enough power to kick the motor in play.

So leaving the contacts in place I am planing to get some semiconductors that let only the voltage go thru one way. this was i can have the two motors connect to the F and B contacts but only one motor would be active at the same time. so when i push forward it would give a 1.0 torquy take off and then pushing the back button would give me a good take off.

sorta like VTEC, low and high end power. I can't wait. Also the guy that hosts the Japanese site e-mailed me with a possible escape route for semiconductors, by removing the follow FET's it would improve voltage he says. What do you think?