- This thread has a good diagram of two resistors you should jumper (or at least jumper or replace with smaller resistors, which did)
http://tinyrc.com/forums/showthread....threadid=1736.
I am posting a picture of my board with the other two resistors to jumper or replace. They are marked in red.
- The NPNs (before I took mine out) got within 0.35 volts of ground. Darlington NPNs might get you to 0.2 volts.
- I definatly noticed an increase in power when I jumpered the resistors. I got around 5 to 10% increse I think. When I put in the MosFETs I got around another 5 to 10% increase. My testing was motly how well it ran on carpet and what slope it could climb. Electronics wise, I went from about 0.85v to about 1.1v to the motor.