Quote:
Originally posted by alpha_003
i found the oh so searchedfor U-joints!!!!! finally i can begin my creations!!!
here the link:
http://bearlocomotive.com/product/X0001
im just curious, is 6mm too thick for the 1/32 scale driveshaft u joints??? oh well....trial and error!!
-Lino
|
hey thanks Lino!.. that u-joint would save you hours of work!.. 6mm driveshaft is fine for 1/32 scale.. if your building a rockcrawler, that would be more than enough!
.. show us your project.. perhaps we could make some suggestions and answer some of your questions!