[bengali548]

okay ive had my xmod for less than half a year i bought it from ebay and i THOUGHT it would have been heavy duty but i was wrong. my dog bones are broken that damn clear back piece is lost (probably because its clear and when your xmod taps something it falls off) my FETS are fried and ive WASTED over 100 dollars on this. now if i replace my fets and things dont go well well that means i have to buy a new board which ig going to cost me 40 dollars

but this isnt a complaining thread

so i wanted to know what i need to make my xmod a beast and i would never have to worry about pushing my xmod to its limit

also about the fets why do you need to solder it. i know its for added strength but when the metal pins make contact with the board is there a connection becuase i was worried about not taking out ALL of the left over soder and it would block the connection.

and lastly why would you need to remove the left over soder becuase doesnt the soder just act as a bride and couldnt you just soder the FET to the left over soder