[gyrate]

in its current state. i have a new lightbar glass i need to paint. this one is not good and i haven't mounted it. i need to apply some decals and hide the wiring + leds from the front in the lightbar underside. just minor stuff i haven't had the time for. been busy with helicopters



i also need to chrome the spotlights so they look like such..



the front might be a little too high but that's because the weight pushes the rear down. i can compensate for it but haven't. you cannot tell unless you are looking for it.



if it was humanly possible to light the directional bar, i would. there is just no way it can be done by a man. the receiver antenna is insulated by a rubber gasket, so it never touches the roof/body. it is not a bare hole in there