|
Am going to make another this time I’ll take a photo of the tie rod and pin before I put it together since this one doesn’t want to be disassembled for a photo.
It’s just an aluminum piece with a grove like an upside down U for the pin to fit into epoxied on to the plastic tie rod. You can’t use the stock bracket because the micro servo’s are always offset to one side. On the first two I did I used a screw for the horn pin but this time I heated up a 1.5mm round 5mm long flat headed metal pin and pushed it backwards through the servo horn hole. What you end up with is sort of a backwards version of what an Xmod uses. The pin points back towards the servo, with the tie rod grove closed at the top and bottom. The top of the aluminum piece is thin enough to pass betweent the servo horn and the servo body, very smooth and very secure.
|