|
hugh i dunno, all i know is 1 set of fets is positive and the other is negative... i looked over that sheet relgiously and this is all i can come up with, my order will b in on friday so ill get to solder on sat and ill update u guys by then.. if u want try wut im saying, have all the fets seperate.. its worth a try right?
also i read over ur post, the heat sinks are through the drains, if they were through the gates ud have issues with the fets opening/ closing... i also know its the drian cause i didnt have this issue b4, then i ran my motor and whamo it heated up, i now know my fets are fried cause they are always open, i.e. the short occurs as soon as i apply power
if u dont understand the concept of a fet its simple.. power goes to source, the gate (a low power source) opens and allows the electricity to flow through the drain.. its basicly a switch controlled by electricity and allows a small power to controll a large power
hope this helped..
|