|
Well, i am not THAT lost..i made one, but i used the wrong choice of FETs which made my setup lose all the energy (4.8 volts to like 1 volt!) So i dont want to make the mistake again...if i use any of the FETs listed above (2 each N and P channel) it should work? I just need some advice on what to look for in a FET...like is there certain things too look for such as voltage or something eles?
What dose PD mean (Power Dissipation)? What PD do i want, and dose it really matter? I am gessing lower is better, as it means how much power is LOST? Someone please tell me! Also, what is the most likly higest ampage i would run with an xmod? Like 5 Amps of so?
I know i can do this, it just that the FET itself is hard to find..Digi-Key would need a 16 S+H fee, and well, that is a big waste...so the best i can do is e-sonic due to the fact the have a Web site AND i can take a bus there...
|