[sg219]

The Nelly 1.2 wires come up between the motor mount and the elctronics. The wires are ran on the bottom of the mount (rear/thin motor mount) and to the sides or corners of it, then up. I suggest replacing the motor mount once you have Nelly 1.2 installed and ready. This way you can have the wires routed proprely before putting the rear drive back on.





Yes, I know i said a Honda body at the beginning of this, but I like the one thats in the pic better!! It's whats eventually going to be on it anyway!!









Now there's is only one more thing to do!! TEST IT!! Thats the End of night one!! The next night we preformed the 6 cell modification on it.







This mod here is well documents, so there is NO need for me to explain this procedure!!





You can see here that the extra cell holder has been installed. It is directly wired to the loop and has a peice of velcro on the backside which attachs it to the top of the heat sink securely!!

Cut all the wires off the cell holder for this app. There is already enough wires around, so get rid of them. Solder the cell holder to the actual loop wires by useing the metal grommets on the end of it. By doing this the mod comes out looking much cleaner and precise.