At this point the steps are...
Break car down to the parts that you are going to be working with.
Think about how your going to go about the whole process, from beginning to the end. Play close attention to where you intend on mounting, placing, soldering, routing, any parts and/or wires.
Start work on the install.
I had great help in doing this. Bird from BitPimps and R7R did all the soldering and I asisisted the entire install. He loves to practice soldering and I just really don't have all the pantience in the world right now. So Bird got the practice on this install. Next one's all me.
THANKS BIRD FOR YOUR TIME!!!
(The pay wasn't that bad either.
)
OK, back to the install. Ph2t has a PDF that he made up to assist in doing the install, so I'm not going to go into specific here. Go read his Nelly Development Thread over at
AusMicro. It'll have all the details you need for a successful install and info on the furthering development of Nelly into the BEST 1:28 scale MOD Board available!!
The Nelly 1.2 connected and tested.
Put in its place very carefully. Rear of chassis veiw.
Here you can see where the wires were routed.
Nelly 1.2 installed.
