|
sb problems
Yesterday I tried puttiing spin brush magnets into my blue RS S2 motor. I followed all instructions and removed the end cap carefully using tiny screwdriver to make sure brushes dont get damaged, I used paperclip method to take out u clip and than magnets and I put in the spin brush magnets and put everything back carefully, but after that for some reason the brass pinion gear was touching the metal can. Well I decided to try it anyways, i noticed its much harder to pin the pinion but i put it back into the car hooked everything up and the car worked. I knew magnets were in properly because car went forward on gas, but it had no torque whats so ever, horrible acceleration and no top speed either. I decided to put old magents back into blue motor and its still bad, did i somehow ruin the blue motor? if yes I wanna try spin brush magnet swap again into my other stage 2 motors.
Maybe you guys know what my mistake was, or the reason why this swap didnt give me anything but ruin performance. All help will be appreciated.
thanks in advance
|