|
ok i will do my best
first you have 2 dremel out a section of plasitc under the u joint. Then you have to take the suspension out, after that you fill the place where the bottom of the suspension is held in. After that has dried drill a small hole directly under the a-arm mount, then place the suspenion in normally. This makes the a-arm higher than usual causing a lift in the rear, formally known as a lift kit. Iam sorry nothing for the front yet. That wasnt as hard as i thought it would be
__________________
"Paul if you flipped the on switch, your xmod would work."
"What would you do for a Klondike Bar."
|