Quote:
Originally posted by shadowblade
If they are waterslide decals, cut out the decal you want, then dip it into water for like 10 seconds, set it on a towel, wait a few until the decal loosens and can be slid around on the paper, Then slide it onto your car where you want it. smoothe it out and let it dry.
|
exactly. And this goes for anyone else: when you apply them, put the whole setup on the car in the area that you want and slide it off onto the car. make sure it stays wet enough so that if you need to, you can adjust. Also, don't be afraid to add water to keep it moist enought o move. then when you're done, get off all the water either with a towel(VERY CARFULLY) or like your hand and then I definitely recommend putting on a clearcoat!