[miketre]

I rewound an X-speed onto a blank armature with a big shaft. With this motor, when i hit full throttle and the green light on the ESC comes on, wheels would not stop spinning and I lose control of my car.
This problem does not happen with the stock motor. I have tried installing ceramic caps on the x-speed buy the problem persists.

I thought that it might be because the receiver was not getting any power when I hit full throttle, so I installed a big 6800uF capacitor across the batteries. This too doesn't help at all.

Has anyone tried running a hottor motor (speedy, A-BB, atomic tuned, etc) with the ver2 ESC?
Any suggestions for my problem?

btw, i'm running 6 cells, ver1 receiver n servo and ver2 ESC

Thanks for any replies.