low ride steerin???
 

...is there a way to get better steering on a lowrider?this thing is low(about 1 pica of the ground) i keep makin it lower and now im satisfied..but the steerin SUCKS!any suggestions?:confused:

not to be critical...
 

but a pica is almost 3/16 of an inch.

hue35

..they kicked me out of Graphic Arts a pica just sounded good i can only run this car on a table or cardboard...

Are the wheels rubbing, or is the body rubbing on the stabilizer bar? Maybe take the bar off, file down the part of the knuckles that work the stabilizer and shave some of the inside of the body off around the stabilizer area and wheel openings if needed. Also, maybe a stronger spring and stronger magnet...

hue35

..i already have better springs..but ill try takin of the stab. bar ect. im goin 2 try that now thanks.. have u tried that yet?..

I have had mixed results without a stabilizer bar... it's been awhile. If I remember right, it steers wider without it. If your lowering job is preventing it from moving, I think you'll be better off without it. It sounds like it might be one of your only options in this case.

hue35

i found that steering w/o the bar SUCKS......... well for my lowered bit at least...

i think im just gonna leave it as is (it's pretty low...) and jus add a lip or something..

...i got my steerin back..i just shaved a little bit from top of the steerin bar and a little off the body..just like new!..:D