dual batt mod with two 100 mAh nimh battery
 

how well would these two work in a zipzap? if it does work would i be able to run a 3.2 motor?

should work ok as long as you dont fry the batts in the soldering process,,,and yes it should run the 3.2 it did mine

Hi peeps,,

If you do this mod,, I really recommend that you do a Bit PCB swap too,, that way you'll get the most juice to your 3.2 motor. I wasn't too impressed with my 2 cell ZZ, it was faster than original, but not even close to my 2 cell bit. After I switched the PCBs, then my ZZ was just as fast as my Bit. It is still fun to drive without the PCB swap, but it's just more satisfying to drive with the swapped PCB.

I just wanted to share this opinion with ya,, (I know stridex agrees with this opinion too! huh stridex)

-Bunta out