? 4 Gertman!!!!!
 

Can a guy use a 150 mah cell as a fourth cell in the Spec 2 120 mah pack??? All batteries would be ni m.

Thank You in advance for any advice!
TEAM NITRO

I suppose you could BUT battery life would probably be compromised. What I mean is that total number of times you could recharge would decrease and so would run time. BUT, on a counterpoint, because it is of a higher MAH rating I don't think it would be so bad.

I would say it's a more short term solution..............but then again if you charge you pack carefully (don't let it get hot) and 1st regulate the pack it may be fine. What I mean by regulate is charging and discharging the newly modded pack severly times at very low amperage if you don't have access to a charger that will automaticlly do this.

Gertman,

Hace you had messed around with four ni cad's out a Tomy Bit Char-G in a Epoch? If not what are your thoughts???


Thank You
TEAM NITRO

No, for my 4th cell I used a spare one left over from a friends broken car.

What is your opinion on ni cads instead of ni mh??? More power?
Would the Tomy bit batteries work?


Thank You again!
TEAM NITRO

NiCd's will give you alot more raw power!! BUT, run time will be even shorter.........my guess about 3 min.