For all you who do not understand how to lower the front of your car Read this
 

1. Take th body off of your car
2. Find the front tab of you car that locks into your body. (it is usually black)
3. Trace it on a piece of wood you plastic(the whole thing)
4. Cut it out with an x-acto knife or a scroll saw or any sharp thing.(do not cut yourslelf)
5. Line your cut out piece next to your original one o your car and make sure they line up exactly and are the exact same size. If they are different sand on it to make it perfect.
6. Sand off the TIP of the original tab on the front of your car.(the tap starts big and then gets small. MAKE SURE YOU ONLY SAND OFF THE SMALL PART)
7. Glue your piece right under your original tab with Super glue. Then put you body back on.
8. If it is not low enough make another tab and glue it on but make sure you sand off the small tab of the last one you did.

Thanks, I think I finally get it now! Too bad it won't work w/ my fullsize wheelset...:(

I think it will if you use a dremel and cut it out. But I am not sure. I still have to find out how to lower the back of a car. Does anyone know how to.

Yeah, it's only one step too.

Step 1: Cut new slot in back of car.

:D

http://groups.msn.com/TheAdmiralsLa...ry.msnw?Page=23

^^thats DriveWRX's site and where i found out how to lower the back of my car..thx Drive!!