Toyota Supra custom body
 

http://alain.galluser.free.fr/Z/DnanoSupra01.jpg
http://alain.galluser.free.fr/Z/DnanoSupra02.jpg
http://alain.galluser.free.fr/Z/DnanoSupra03.jpg
http://alain.galluser.free.fr/Z/DnanoSupra04.jpg
http://alain.galluser.free.fr/Z/DnanoSupra05.jpg
http://alain.galluser.free.fr/Z/DnanoSupra06.jpg
http://alain.galluser.free.fr/Z/DnanoSupra07.jpg
http://alain.galluser.free.fr/Z/DnanoSupra08.jpg
This is an Epoch spec1 body that I had left. This will be for racing so I can preserve the beautiful Murcielago body.

Very cool A - can you show some pics of the modifications needed to convert from Epoch to dNaNo mount? Thanks! :)

Well that was a 10mn job done before a race so not esp. fancy looking but it works :)

Front I ca glued some foam block cut in shape with a slit for the front mount.
For the side mount they are just screws that go through the body with some cable insulation to give some thickness to the screws reproducing the Dnano pegs. I could use plastic tubing but I could not find some in the correct diameter.

Don't mind the shaving under the hood, that was an attempt to lower the body when it was in use with the Epoch chassis.

http://alain.galluser.free.fr/Z/DnanoSupra002.jpg
http://alain.galluser.free.fr/Z/DnanoSupra001.jpg

I later removed the foam side rails you can see on the above pics. The purpose was to protect the chassis from side shocks.

Very cool, thanks A! :)

The sides are exactly what I had planned for my Honda Z. Thank's! Not sure what to do for the front though yet as it's a completely different front end than yours. There really isn't much of a front on the Honda Z yet.

A different body mount set might give you a shorter front tab if you need it. When I get home I can get around to finally measuring mine and give you an idea.