TinyRC.com

TinyRC.com (http://tinyrc.com/forums/index.php)
-   Bit Char-G / MicroSizers (http://tinyrc.com/forums/forumdisplay.php?f=10)
-   -   Nikko i Truck (http://tinyrc.com/forums/showthread.php?t=19279)

slotsurfer 05-08-2004 08:54 PM

Nikko i Truck
 
1 Attachment(s)
I just recived in the mail from Tower hobbies the coolest Micro rc.
It the Nikko I Truck.It has a hummer body and rubber tire is fast it runs on shag carpet. The controller is cool also it use a single joy stick to control the Truck.It goes over all kinds of stuff I drove up the pile of track boarders for the photo. It use Bit steering and is totally sealed in so I guess you could run it in the dirt like they show in the videos on Nikkos Japan site.I am affraid to take it apart to see what size motor in it because it such a cool truck.

filelicker 05-08-2004 10:09 PM

Do you have any other information on this ? I can't get any from tower hobbies on this , it doesn't come up at all on their site.

slotsurfer 05-08-2004 10:53 PM

Here's the Links Tower link Nikko Usa jeep
Nikko Usa hummer
Nikko japan video page the top video is only 1mb the bottom is 3 mb.
.Nikko Netherlands commercials Has Iracers,Ibike, Iboat,I trucks It look like they have body for a BMW X suv for their Itruck chassisPackage and controller photos Check out this French site that has how to modfiy Itruck and video

Racer9 05-09-2004 10:12 AM

The I-riders are cooler but this is still cool! Does it turn while on carpet?

slotsurfer 05-09-2004 11:04 AM

The Itruck runs over shag carpet like it not even there, I have these runner carpets that get bunched up and form hills and jumps and goes up and down them easily.I found out the reason if you look at the last link on a french site on how to modfiy the truck.It has a large servo motor not a little pager motor.Also it has a self contained trasmission attached to the rear axle that pulls out.Check out his video if you like climbing or swaper trucks you will like the video. The Itruck blows away my tomy wild charg easily:D

Racer9 05-09-2004 04:24 PM

Cool! Sounds like I will have to get one! Can you change the rear motor?

slotsurfer 05-09-2004 09:07 PM

Looks like it if you can find the right size motor. You will have to do some soldering also. I am a Modder but Nikko did such a awesome job on this car i am going to leave it alone except i might order the Jeep rubicon body.You can order a new body and chassis from Nikko.


All times are GMT -5. The time now is 06:21 PM.

Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.