Will the abc dtm sp motor mounts fit the DRR
 

http://horizon.hobbyshopnow.com/prod...?prod=ABC62530
Will the above motor aluminum motor mounts fit the DRR
Thanks,

Well you would have to buy flanged bearings (its does come with bushings it seems), and then you would have to redrill the rear pod to accept it. Also realize the SP is mid mounted stock, so you would have to take that into consideration also.

Unfortunately I think your most likely stuck with this:
http://horizon.hobbyshopnow.com/prod...p?prod=DYN8222

That what I thought I was just trying to get a cheap aluminum heat sink.Looks like Dynamite won't make them I just emailed Percision model products about his products.Plus it includes bearing for about the same price. I was dreaming about all the graphite and aluminum and graphite titainum axle for a DRR with parts from Percision cost $187.00:D
http://gallery.bcentral.com/Gallery/...=1&sortOrder=0

for that much you could get an sp which would work even better.

I know I know:DBut you would think their would be more upgrades for a ABC DTM SP.But you can't find none. I just played with my New DRR yesterday a lot of fun. Need to get the abc mini cooper/rally monte carlo body. I just need to find a Japaneese retailer.

That place you listed above seems to have a few (like the titanium axle). Other than the bearing set, for either kit, upgrades arent that important unless your racing these? Graphite is lighter and tougher, but its also more prone to cracking.