Mini-x heatsink
 

http://tinyrc.com/gallery/trcheatsink/aaa

Anyone got this, or know where to get it? Is it any good?

That was a modified heatsink made from an old computer heat sink.

Cheers & Thanks Itan!
Gues It's back to the drawing board..

i need one of those

3SeriesTakumi, what Kinda motor you running??

3SeriesTakumi is a crazy driver you dont even want to know

i was running an hpi micro mod but it was too fast for the car. i had it top mount over an alum shaft to fit it. for now i use a pn-speedy motor with a BB can, neo magnets and a shaft extension.

Mmmm, sounds good!
I reckon I'll try a stock armature in a MiniZRacer A-BB can with the magnets from that, to see how it runs.
Putting the micro mod into the mini=x must be like a Micro 540 conversion. you must have lost bits of the drivetrain all over the place! :D

I'm sorry, that's not correct at all. The car pictured is mine. It was a custom sink we designed from the ground up and had prototypes machined. It never made it to the mass market, but, if enough people are interested we could do a small run.

btrc

Check out this old thread.

http://tinyrc.com/forums/showthread....&threadid=5017

Tho it would be tough to get that into the stock motor mount, so probably wouldn't do much good.

is your current setup good to kill mini z(s)? can i use an high rpm motor but compensate with neo mags?(eg.plasma dash)
---------------------------------------
Mini X
7 cells AAA
Futaba mc230cr Esc
Hitec hs-55 servo
Pn Racing bb can
Pn Racing carbon brushes
10v 4700uf cap(tested)
16v 4700uf cap(not tested)

the plasma dash has no torque to move the car. and while it is trying to move the car, it is eating your electronics alive lol. my hpi setup could keep me at pace with a mildly tuned rs4 micro. my current neomag pn setups puts me faster than most miniz. and since i have ALOT of torque and 4wd i can power thru and out of corners way faster than a miniz ever will.

after i saw i could do that, i realized i was done