Ahh5hit, answer this question for me.
 

i was going to lower by body on a Supra, Skyline, and a Evo, but when i cut the tabs out, i couldn't bend them to the right postition! it took hous trying to cut them and bending them right, but no luck... could you tell me how you cut the taba and aslo how you bent them so perfect. THX

If you are talking about the existing tabs, I cut them completely off. I use an credit card to make the new tabs. To bend them, I use 2 Gerbers or pliers which are the same width of the new tabs.

Another thing.... what did you cut it with?!?! i do it with a razorblade.... takes forever!

Good Grief, everyone knows that you use an X-acto or hobby knife to shave of the existing tabs and a scisor to cut out the tabs from a credit card!!!!

You can do it like charliebrown said. I use a dremel with the bit in the pic to cut the existing tab off. I use scissors to cut the credit card and that same dremel bit to notch it.

all but Ahh5hit ignore me:

hey, check your mail, i sent you something you may find interesting:D


ok back to the topic, sorry about highjacking this thread but this board has private messaging disabled:rolleyes: