Best Booster PCB?
 

Well, as many of you remember i was the one inquiring about methods for project Ultimate 350Z.

I got the wheel swap all done and i must say, it is awesome. However when i was handling the car i accidentally removed the wire i had soldered to my motor clip (i have a dual cell). While attempting to re-solder, i wasnt paying attention to my soldering iron's heat and unfortunately set fire to the rear of my bit char-g. My question is this: should i swap my bit booster pcb into a spare microsizer chassis, or buy an LXX or MS pro? Boost is a must for this project, as well as good range. Which pcb puts out the most power to the motor and which has the best range? Any help will be appreciated. I will try an snap some pics of the pullback wheel mod soon (i managed to make it so that both wheels stick out equal amounts and only about 1.5mm--debating whether widebody is necessary).

The Fairlady PCB has boost, and great range.. At least mine does. I'd say stick with that.. That's my $0.02



silla

thanks payaso!

Anyone else wanna step up to bat?:D

i would go with the fairlady or ms pro cuz lxx doesn't have such a great booster mode...it goes pretty slow even in booster de and especially slow in regular unboosted mode...it looks jittery in unboosted mode...never seen teh fairlady or ms pro but i have heard good things about them

id just drop the boost pcb into a 10$ ms sport. the hardest part is remembering to mark your wires so you dont reverse em. hehe

i agree with hog, it might be kinda hard to do but you save quite a bit of time and it should turnout just about the same.

Thanks guys, looks like its pcb-swap time! *warms soldering iron and grabs spare ms chassis*:D

again remember to mark your wires

is a 3.8 perfection motor good for a LXX booster Am set I am waiting for mine and am thinking of getting the 3.8 perfection

Toy East bundles the two together, so... sure!