Dual Motor Mod & other General Questions
 

I have 4 questions:

1. How do you do a dual motor swap?

2. How do you do a dual cell swap?

3. Does anyone know where I can get domestic bdies for Bits?

4. Can you swap LXX wheels onto a Bit?

I have recently wanted a little more power, and my LXX's DKS 3.4 doesn't cut it. Has anyone had experience with Bit Mod 1's 3.5?

questions 1-3 go to
www.questformadness.com

question 4

yes you can both front and back but why would you? they are almost exactly the same except tomy ones r better

Actually, the first question is NOT on QFM, I have a tutorial pic right here:

omg... that's pure intensity...... CRAZY mod....

prolly not as hard as some of the stretching and 2 cell internals that people do, but whoa... pretty nuts if u ask me...

Yea, it would be pretty nuts, but it would work the best with a dual cell. It would have crazy torque.

What d'ya think about the dual motor with the Bit Mod 3.5? I hear it's really torquey. Also, do the motors have to be at the same RPM?

That is the coolest mod I've ever seen!
 

Half the run time, double the torque, sounds great! The gears would lock if the motors aren't the same.

Ya think the torquey 3.5s would be enough to pull wheelies?

And does anyone have domestic bodies?:confused:

I'm not too sure about that one... If you put some weight in the back end then you would probably be able to do them no problem. With a dual cell, and dual 1.0 motors, for sure you would be able to do wheelies.

2 Coins Solved wheelie problem

I'm also thinking about a CO2 Rocket. I built a car that weighs at least 3x my LXX, & It'll do over 60 mph! LXX + CO2 rocket. Hmmm...

:cool: :D

It's a nice day to fly!

Are you crazy? That would blow the car to hell and back! But that sure would be cool :D

Actually, some fishing line ould hold it down (usually on the bottom, but I'd put it on the top) & the quarters would make sparks!

I also just ordered a tomy NSX, and 2 3.5 motors from bitmod1.com, so the dual engine project's a go! :D I'm hopin' for some mind-boggling torque with a single cell (I don't wanna modify my charger). Wish me luck!

Good luck! And, you don't have to modify your controller at all! Just make a stand alone charger. I made one, with pieces from an old controller.

I just did it on a clone! It's pretty bad-looking, but it hauls!

Cool! Does it have more speed, torque (that stupid word takes me like 5 seconds to type), and did you do it by the tutorial?

Hehe that dual motor looks AWSOME :D


It wouldnt stay charged for as long would it??


I think you should do that c02 thing (with a cheap clone) in a drag race :D !

I sorta followed the tutorial, except I did it with tape and copper wire to see if it'd work. The car has A LOT of torque. the body won't fit back on, but if you were using a body with a hole in back, it would take some trimming. I also had to trim the chassis a little bit with a swiss army knife (I reccomend flattening what you want to cut out with needle-nosed pliers, so the job is easier), and the best part is, if for some reason you can only use 1 motor, it's easy to change back, unless you don't have any Heat Sinks