1/24 scale WWS Pro

[t3bastler]

Here are some (unfortunately low quality, sorry) pictures of a 1/24 scale WWS Pro with
Mabuchi FK180, 2WD, selfmade electronic, forward/reverse mosfet speed controller (6Amperes) with
brakelight-backlight-headlight-R/C-controlled-on/off-function.
The body is a BMW GTR M3 because there is more space inside so i can use standard
mini-steerservo and standard R/C receiver!!

[t3bastler]

one more pic

[t3bastler]

more, more

[t3bastler]

without body

[irc]

I see headlights! Nice.. IM also running the BMW body but IM painting up a Opel now. The Opel wheel base is longer so IM curiouse how it will handle. Can you give us any tips on handling or any mod's you have done.

[t3bastler]

Sorry, but i havent done any mods on the car itself.
I use the chassis as experimental for my pic programmed curcuits and for fun (Drivin in the Living room is very funny).

One more thing ive done is the backlight/brakelight.
It consists of one led, left and right, only, so i have to dim the led during driving. While braking the leds are fully on. (Oh my goodness, what a bad english).

The next thing ive done with the speed controller too, is that i can setup to different R/C controllers. This helps to use the speed controller in several car models.

The WWS is my first contact with scale smaller than 1/10 - I think there are a lot of more possibilities. I will see...

[3series takumi]

where did you get that 1/24th body, i need that!

[t3bastler]

No problem, you can get that body here:

www.rc-tiger.com

its item 5109 - BMW GTR Euro 12.80

But I dont know if it is available outside Germany.