? 4 Gertman!!!!!

[TEAM_NITRO]

Can a guy use a 150 mah cell as a fourth cell in the Spec 2 120 mah pack??? All batteries would be ni m.

Thank You in advance for any advice!
TEAM NITRO

[gertman]

I suppose you could BUT battery life would probably be compromised. What I mean is that total number of times you could recharge would decrease and so would run time. BUT, on a counterpoint, because it is of a higher MAH rating I don't think it would be so bad.

I would say it's a more short term solution..............but then again if you charge you pack carefully (don't let it get hot) and 1st regulate the pack it may be fine. What I mean by regulate is charging and discharging the newly modded pack severly times at very low amperage if you don't have access to a charger that will automaticlly do this.

[TEAM_NITRO]

Gertman,

Hace you had messed around with four ni cad's out a Tomy Bit Char-G in a Epoch? If not what are your thoughts???


Thank You
TEAM NITRO

[gertman]

No, for my 4th cell I used a spare one left over from a friends broken car.

[TEAM_NITRO]

What is your opinion on ni cads instead of ni mh??? More power?
Would the Tomy bit batteries work?


Thank You again!
TEAM NITRO

[gertman]

NiCd's will give you alot more raw power!! BUT, run time will be even shorter.........my guess about 3 min.